Body Work

[89GTA]

hey, im trying to repair some front end damage on the drivers side of the car. im haveing some trouble removeing the panel though. it seems that its bolted onto the ground effects from the inside in a spot where no tool i have can get to it. so i started removeing all of the screws for the ground effects and to my surpise, the part on the rear is ALSO bolted on from the inside. now i dont want to have to remove every friggin panel on the drivers side just to change this panel. does anyone here know how i can get the front drivers side panel off? i have every single screw off exept the ones to the ground effects

[Red88GTA]

If you are where I am thinking. I had to remove the battery then remove the two screws underneath the battery to remove the vacuum reservoir that is blocking access to the ground effects to the fender. Then I was able to get to the remaining nuts to remove the ground effect. There is one screw bolting from it to the front nose and you just have to have the car up in the air and reeaaach up in there and get it out.. Everything is 10mm. Hope this helps.

[89GTA]

i got the front end bolts off, there are only two holding the fender to the gfx. there is no way i can seem to get my hand in there, let alone a rachet. some guy told me that the fender should pop off the gfx if i lift them up, but that doesnt seem to be working. i cant even tell how the freakin factory put this thing on, it seems im possible to remove or install :(